1 / 3
Modular Filament Drawer System ( pvc pipe remix )
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Cheaper version of the modular drawer for filament storage. PVC pipes instead of slides.
- Ocena
- 5 / 5
- Polubienia
- 57
- Pobrania
- 152
- Wydruki
- 1
- Wyświetlenia
- 1627
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Organizers
- Licencja
- Creative Commons — Attribution
SzczegółyPliki (5)Wydruki i komentarze (Wydruki: 1) (Komentarze: 14)Remiksy (0)Kolekcje (102)Powiązane
The length of the drawers in this design can be used in a flexible way.
But all pvc pipes should be cut in the same length.
Diameters of the pipe should be 20mm ( 4 times ) and 16mm ( 2 times )
( the links are to show an example of what I used )
All holes are M3 based. Length of screw used: 16mm-20mm.
Total filament used: 315g ( 15% infill )
Assembly
- Drawer
- Take the Front Plate and 4 x 20mm pipes and fit them in the holes.
(you can already screw them in.) - Take the Front Frame and slide it over the 2 bottom pvc pipes.
- Take the Back Plate and place the 4 pipes in the holes.
( only the top 2 should be screwed in)
- Guiding “system”
- Take the Back Frame put the 2x16mm pipes in their holes and screw them in.
- Secure the Back Frame to your rack ( screw them in/secure with a clamp)
- Align the Back Frame with the guiding system
and slide the 20mm pipes over the 16mm pipes. - secure the front plate with screws in the front.
This is version 1.
It is a quick remake without trying to look at the original design to much.