1 / 1
TPU Bumper for Peak Design Anchors (E.g., Capture Clip)
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A TPU bumper to prevent the clips rattling or scratching the camera
- Ocena
- 0 / 5
- Polubienia
- 12
- Pobrania
- 31
- Wydruki
- 0
- Wyświetlenia
- 350
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Photo & Video
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
SzczegółyPliki (1)Wydruki i komentarze (Wydruki: 0) (Komentarze: 0)Remiksy (0)Kolekcje (14)Powiązane
A little bumper to prevent the anchor/clips rattling and scratching the camera. I made this mostly for the Capture Clip as the wrist strap rattles while walking.
Print with the open end on the build plate out of TPU. To install place over the anchor and install the clip/sling. Then slide the bumper back over the clip.