floor lamp

Required filament

• Prusament PETG Galaxy Black
• Prusament PETG Clear

Print instructions

• the shades are printed in "vase mode" with clear filament (without bottom layer)
• the shade at the very bottom is printed in galaxy black to hide the led controller inside
• no support
• 20% infill for everything (except the shades - vase mode doesn't have infill anyway)

LED Stuff ordered from Aliexpress

• LED Controller: SP105E Bluetooth LED controller
• LED Stripes: DC12V WS2811 5050 60Leds IP30
• Power Adapter: 12V Power Adapter

Assembly

1. Start with the at the very bottom
2. add black shade
3. insert LED controller + connect LED stripe (don't cut it yet)
4. add intermediate piece, push stripes thru first rail and stick it to the intermediate piece
5. add shade… repeat from step 4 until you reach the wanted height
6. cut LED stripe at the very top
7. add top cover (can be a bit tricky - patience is the key to success)

Reddit post (video)

• https://www.reddit.com/r/prusa3d/comments/qczhk7/floor_lamp/