Anet A8 right side brace/stiffener
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Note this works well on my Anet A8 from 2016. Since then new versions and clones from the Anet A8 have surfaced which…
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 17
- Wydruki
- 0
- Wyświetlenia
- 102
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Note this works well on my Anet A8 from 2016. Since then new versions and clones from the Anet A8 have surfaced which may not be compatible with this thing. Please make sure before printing that the part lines up with your printer geometry!
A right side stiffener to make the frame more rigid. It uses the present holes and slots in the acrylic. I use hex/Allen key screws to fixate the part, these are sunken in the part to not have the right x-axis mount contact the stiffener. Two existing screws need to be removed first before fitting the part.
BOM:
2 * Allen key M3 x 18 for far right screws
2 * Allen key M3 x 20 for replacing existing
2 * Allen key M3 x 30 for mounting to vertical part
Few washers
Print Settings
Printer:
Anet A8
Rafts:
No
Supports:
Yes
Resolution:
0.25
Infill:
25%
Notes:
Orange PLA @ 200 degC, 50degC aluminium heatbed with 3D-LAC (directly printed on heatbed with 215 degC/60degC), 6 mm brim (260% first layer extrusion [SLic3r]), no raft, no supports, 0.25 layer thickness, 25% infill (honeycomb) and 1 mm thick walls (4 layers).
Print scale 1.0.Post-Printing
Although this stiffens the right corner, the top of the printer still shows some flexibility. The reason for this is that the brace should preferably be attached higher (e.g. to the top plate). The printer bed is too small for printing such a part length I guess.
I think I will modify the printer in a later stage by acquiring an acrylic plate to cover the full height replacing the current second Z-axis motor back plate.
Category: 3D Printer Parts