Husqvarna Viking 1100, 1200, 1250, #1, #1+ Stitch "Cassettes"
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
These are the A, B, C, D, and E stitch cassettes for the Husqvarna Viking 1100, 1200, #1, and #1+ series of machines.
- Ocena
- 5 / 5
- Polubienia
- 8
- Pobrania
- 227
- Wydruki
- 0
- Wyświetlenia
- 1401
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Ideas
- Licencja
- Creative Commons — Attribution — Noncommercial
Project Inspiration
Hi. I recently purchased a used Husqvarna Viking 1100 and it was missing the stitch cassettes. The 1100 originally came with 4 cassettes, A, B, C, and D. However I was able to find a combination to make an “E” cassette work as well.
These cassettes are rare in real life because they get old, crack, and people throw them away. Because they are rare, they are expensive. (Typically $40 for a SINGLE cassette!)
The 1200 series of machines (and 1100A?) uses MORE cassettes, so I've included a “test” cassette you can play around with to try to enable more of those cassettes. Just use a piece of cardboard or index card or whatever to push down the various little switches inside the machine on the left side of the cassette. (See how there are different little slots open for the different cassettes?) There are 5 slots total that correspond to 5 little physical switches inside the machine. Different combinations of these switches will enable different stitches. If the machine beeps after you put a combination in and press a stitch button, that combination isn't allowed.
If you figure out some that work, please message me here and I'll make new files and post them here.
For any cassette you want to print, you'll need the cassette and you'll need to print out the pins/buttons. I created an “organized” version of the pins so you can just push the cassette down onto the pins while they're still on the baseplate and they should all fit in the holes. (Much easier than doing it one at a time.) However, I also included a single pin in case you need extra.
Print Settings
- Material: Any really. This is an indoor project. PLA works fine.
- Layer height: I recommend at most 0.15 mm Anything smaller is fine. Adaptive layers is fine.
- Nozzle size: I used 0.4mm and it worked fine. Anything smaller would work fine as well.
- Supports: None. The models print fine without supports on any reasonably well tuned machine.
- Speeds: I also slowed down my machine to about half my normal speed. If I printed it faster I got some stringing inside the holes of the cassettes which led me to have to clean them up before inserting the pins. That could have just been a “my machine” issue.
Tips
The pins don't always stay put (3d printing isn't perfect after all). I recommend placing a label over the entirety of the pins to hold them in place. You could even print out a picture of what the cassette looks like so you could identify the stitches! You'll need a label 2.25 inches tall. (Or just cut a larger one down.) The only pre-made labels with that height and enough width I found were 2.25x7.75 inches.