spiral blowgun
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
inspired by the spiral fidget toy, my brain immediately went to 'blowgun'.
- Ocena
- 0 / 5
- Polubienia
- 5
- Pobrania
- 51
- Wydruki
- 0
- Wyświetlenia
- 294
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor Sports
- Licencja
- Creative Commons — Attribution — Share Alike
inspired by the spiral fidget toy, my brain immediately went to 'blowgun'.
i might tweak it later to function better but im sure one of you out there is a total pro at blowgun stuff. so print it out & play with it & give me your input
i designed it to slip into a 1" schedule 40 pvc pipe. this should let you add length if desired. the outside diameter is 1.029" so you might be able to use a carbon fiber with a little sanding. if you use scaling in your software then keep the Z axis the way it is.(it affects the twist rate) the twist rate is approximately 180 degrees per inch.
the projectile is scaled down to 85% in the X & Y axis. ide say its pretty generous tolerance but it is what works with my printer. tighter tolerances might add more speed.
the projectile is the approximate profile of a rifle bullet. my thinking is that the spiral will give it more range by adding some thrust because its effectively a flying Archimedes' screw
i print the projectile in vase mode to save time & filament. print the blowgun mouthpiece down with supports. its 264mm tall so it fits an ender 3. i did 2 walls 15% infill
Print Settings
Printer Brand:
Creality
Printer:
Ender-3 S1
Rafts:
Doesn't Matter
Supports:
Yes
Resolution:
.2
Infill:
15
Filament: any pla any
Notes:
264mm tall.
Category: Sport & Outdoors