Controller Under Desk Holder
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A holder for a controller that is screwed under a wooden desk. (Design specifically for 8bit do Ultimate Wired C)
- Ocena
- 0 / 5
- Polubienia
- 13
- Pobrania
- 98
- Wydruki
- 0
- Wyświetlenia
- 545
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Video Games
- Licencja
- Creative Commons — Public Domain
Introduction
I designed and printed a holder for my 8bit do controller that i wanted near my computer set up, also you can use this holder for other controllers.
I needed it to be:
- Close but not visible
- Easy to reach
Print Settings
Printed on: Sovol SV06
Slicer: Prusa Slicer
Material: ELEGOO Rapid PLA+
Print Settings:
- Supports Everywhere (Honeycomb Pattern)

[Note: In the slicer i placed the marked face at the bottom to reduce printing time]
- Infill: 30%
- Layer Height: 0.2 mm
[Note It is not necessary to use 0.2 mm for the layer height]
Other
- Flathead Wood Screws (Diameter~2.72mm and Length~34mm~1-1/3")
[Note: This may vary depending on your desk, see that the model actually has a kind of washer or spacer i put that in the model because i didn't have any screw that was shorter]
- Other controllers i fit tested were:
Fit: 8bit do Ultimate C Wired, PS1, PS3, PS4, PS5, Nintendo Switch Pro Controller.
Don't Fit: Xbox 360, Xbox One, GameCube.



Conclusion
This is another model while practicing using OnShape to create my designs.
Please feel free to comment and give any feedback to the model.
(:
