Forearm Trainer
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
It enables to train your forearm with just adding some offset weight
- Ocena
- 0 / 5
- Polubienia
- 40
- Pobrania
- 112
- Wydruki
- 0
- Wyświetlenia
- 986
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Gadgets
- Licencja
- Creative Commons — Attribution — Noncommercial
Video showing the product:
https://www.tiktok.com/@franky_rnd/video/7298103781785373957
The main idea was to create a proper forearm trainer, using the mechanical advantage of appling the weight out of the center of your hand makes it way harder, so you can reach failure with just 5-10kg by doing 12 reps.
I've done a few variations and this is the one I am the happiest about.
The steel cable should be 3mm in diameter, but its made to accept one a bit bigger. It should not be shorter that 60 cm in order to have a complete range of motion.
It has the hole for four 2.8mm in diameter screw, but in my testing they are supper optional. the length that I've use is 30mm.
Link for the cable:https://shorturl.at/bgFM3
I recommend also using 2 crimping loop sleeves.
Link: https://shorturl.at/glvxM
Remember to add only one of them before assembly and then add the other one.
Printing
Printed in PLA, but recomend using other if it will stay outside.
Layer height: 0.2mm
Infill: 25-30%
Brim: optional in the handle
Mousears form orcaslicer optional in the cable guide.