1 / 4
Vase Mode Sharps Disposal for Box Cutter and Razor Blades (Gridfinity Compatible) — zdjęcie 1
1 / 4

Vase Mode Sharps Disposal for Box Cutter and Razor Blades (Gridfinity Compatible)

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

A disposable vase-mode print to contain used box cutter and razor blades. Use standalone, or in Gridfinity base.

Ocena
5 / 5
Polubienia
21
Pobrania
160
Wydruki
5
Wyświetlenia
854
Oceny
5

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Office
Licencja
Creative Commons — Attribution — Share Alike

Throwing out box cutter blades or razor blades? Don't just throw them in your trash or leave them laying around, or you risk accidentally cutting yourself! Print this quick sharps disposal container instead.

This is a vase mode print, it prints in under 1 hour and uses less than 10 grams of filament. It prints as-is, no assembly required. It is a disposable print, you print this and put your used blades in, then throw it out once it is full. Do not try to open or empty it.

Thanks to the vase mode, it uses very little filament so little plastic is wasted once this is disposed. The design of the model maximizes the strength of the container with a single wall, but please handle it carefully once any blades have been inserted. The container holds up to regular use, but if you squeeze it hard you can crush it.

You can use the print on its own. But if you use Gridfinity, this box will fit a 1x1 Gridfinity square. It has a Gridfinity height of 13 units (91 mm), and is not stackable.

Printing

Select “Vase Mode” in your 3-D printer to print this model. In PrusaSlicer this is under “Print Settings” in the “Layers and perimeters” category, named “Spiral vase”. In Cura find the “Spiralize Outer Contour” and “Smooth Spiralized Contours”. Other slicers may have a similar option. This setting will print the object hollow.

Supports or brims are not required. The prints in the photos are printed with PLA+ or PETG, both works fine.

Customizing

You can use OnShape to customize this model. The easiest thing to adjust is the height: open the variable table, and adjust the height (the first variable at the top). You can also adjust other variables, but changing some of them might break the model and require further changes to fix.

Disclaimer

This is not suitable for use with needles or other biohazardous waste. Keep printed object away from children. This model is provided without any warranty, without even the implied warranty of merchantability or fitness for a particular purpose. This container may or may not fulfill the requirements for containment or disposal of sharp objects in your jurisdiction. Check your local laws and regulations to see if this model is sufficient in your area. The model designer does not claim any responsibility for any harm that may arise from use of this model or objects created based on this model, use them at your own risk.

Tagi