SR Suntour fork top cap for 1/4 inch socket
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Remix of the original sr_suntour_xct_fork_topcap_socket.stl file made by @cmh_13634 to allow a 1/4 inch socket.
- Ocena
- 0 / 5
- Polubienia
- 10
- Pobrania
- 81
- Wydruki
- 1
- Wyświetlenia
- 464
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor Sports
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
A remix (my very first remix!) of the original STL file created by @cmh_13634 for the SR Suntour fork top cap to accommodate a smaller ¼ inch socket wrench.
Remixed the design in Tinkercad, which is why some surfaces are not as smooth as the original STL, but it should not have any structural effects.
It's not an exact ¼ inch (6.35mm) socket but rather 6.75mm, as it was previously too tight for the wrench and disengaging will cause noticeable blemishing, markings and damage.
Print Settings
Printer Brand: Elegoo
Printer: Neptune 4 Pro
Rafts: No
Supports: No
Resolution: 0.2mm
Infill: 20%, Gyroid
Wall: 5 wall loops
Filament: Build It Full PLA Black
Print Notes:
Printed with 5 wall loops and 20% gyroid, but I believe it could be printed with even lower specs and still work as intended.
I did this to provide the print with extra rigidity and strength as it was meant for a friend and to provide a peace of mind for the unpredictable amount of physical beating it will take.
No supports used, printed in place as is.