1 / 1
e.Go Life Halterung für Rückspiegel — zdjęcie 1

e.Go Life Halterung für Rückspiegel

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Neue Halterung, mit der der Rückspiegel des e.Go Life um einige Zentimeter weiter oben befestigt werden kann.

Ocena
0 / 5
Polubienia
1
Pobrania
37
Wydruki
0
Wyświetlenia
347
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Garage
Licencja
Creative Commons — Attribution — Share Alike

----- DEUTSCH ----- 

Der Rückspiegel des e.Go Life ist sehr weit unten montiert. Dadurch muss man sich an Kreuzungen nach unten beugen, um unter dem Spiegel durchschauen zu können. Das hat mich schon immer gestört. Diese Halterung lässt sich an der Befestigung des Licht- und Regensensors montieren und versetzt den Rückspiegel so um einige Zentimeter nach oben. 

Alle Teile können ohne Supports gedruckt werden. Ich habe mit PETG und einer Layer-Höhe von 0,2 mm gedruckt. Die Halterung mit 80% Infill, die Abdeckungen nur mit 25%. Das erste Modell aus PLA hat der Hitze im Sommer nicht standgehalten.

Zum Befestigen muss nur die alte Halterung des Spiegels gelöst werden (ggf. Wärme verwenden, ich konnte ihn durch eine einfache Drehbewegung ablösen). Außerdem muss die Abdeckung des Regensensors entfernt werden, diese ist nur aufgesteckt. Nun kann die neue Halterung von oben auf die Halterunf um den Regensensor aufgesteckt werden, dann die beiden Abdeckungen. Die untere Halterung kann unten mit einem kleinen Streifen doppelseitigem Klebeband zusätzlich an der Scheibe fixiert werden. Zum Schluss noch die Metall-Platte und den Kunststoff-Verbinder vom Spiegel entfernen und diesen von oben auf die neue Halterung aufschieben. Fertig.

----- ENGLISH ----- 

The rear-view mirror of the e.Go Life is mounted very low down. As a result, you have to bend down at junctions to be able to see under the mirror. That has always bothered me. This bracket can be mounted on the attachment of the light and rain sensor and thus moves the rear-view mirror upwards by a few centimetres.

All parts can be printed without supports. I printed with PETG and a layer height of 0.2 mm. The mount was infilled at 80%, the covers at only 25%. The first PLA model didn't withstand the summer heat.

To attach it, you just need to loosen the old mirror mount (use heat if necessary, I was able to detach it with a simple twisting motion). In addition, the cover of the rain sensor must be removed, this is only plugged on. Now the new bracket can be attached to the bracket around the rain sensor from above, then the two covers. The lower bracket can be additionally fixed to the windscreen at the bottom with a small strip of double-sided adhesive tape. Finally, remove the metal plate and the plastic connector from the mirror and slide it onto the new bracket from above. Done.

Tagi