Kirigami bed nut block for Voron V0.2
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Nut blocks with more forgiving clearances for the Kirigami bed included in Formbot's V0.2 kit.
- Ocena
- 5 / 5
- Polubienia
- 15
- Pobrania
- 163
- Wydruki
- 2
- Wyświetlenia
- 837
- Oceny
- 2
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Voron Parts & Upgrades
- Licencja
- GNU General Public License v3.0
The Kirigami frame that was included with my Formbot V0.2 kit was slightly thicker than specified, as also experienced by SrgntBallistic. This made it very difficult to install the Z nut block on the frame. After installation, the frame was expanded just enough that the rails were binding.
So, I decided to remix the nut block. Each version in the files section has had the width (shown in purple) decreased, and gap (shown in yellow) increased by the amount specified in the file name. The unit is in millimeters. It might not seem like much, but it made a huge difference for me.
The .1 file was still slightly too tight. The sweet spot for me was .2. The .3 was slightly too loose, and the .4 would fall off by itself. Try out the different sizes to see what works the best for you.