Golden Spiral Clock - 3 sizes

This clock uses the golden spiral (Fibonacci spiral) to indicate time.

Nozzle = 0.4mm

This is designed to be use with this clock movement.

There are 3 different sizes.

Mini would fit on the Prusa Mini, Bambu A1 Mini or equivalent printers.

250 size would fit on the Prusa Mk4, Bambu X, P, and A1 series printers. 

350 size would fit on the Prusa XL or equivalent printers.

Note: The clock face must be rotated to fit on the print bed. Do no scale up or down because the holes for the clock movement will not fit properly.

Assembly

Gather all your printed parts, clock movement parts

Place the hanging hook as shown through the clock movement

The hanging hook should be flush as shown

Insert the clock movement through the clock face, place the washer through the movement and secure the movement using the included locking nut.

Turn the clock over and gently adjust the movement so that its edge is parallel to the edge of the clock. This step is important so that the clock would hang properly.

Very carefully using both hands and push the golden spiral hour hand into the outer ring of the clock movement.

Properly installed golden spiral hour hand should look like this.

Now using the adjustment knob on the clock movement on the back and rotate the golden spiral until it is a 11 o'clock.  Then using the same method, carefully install the minute hand pointing at the 12 o'clock position as shown. This is very important so the hour would be properly indicated when completed.

Glue the second hand button into the second hand as shown.

Once the glue is cured. Align the second hand with the center post of the clock movement and gently and carefully push the second hand down. 

Adjust the time to your current time and hang it up :)

Enjoy :)