1 / 11
Jayco 242BHS Bathroom AC Duct Redirect to Lower Bunk — zdjęcie 1
1 / 11

Jayco 242BHS Bathroom AC Duct Redirect to Lower Bunk

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Redirects AC from bathroom ceiling vent to lower bunk wall.

Ocena
0 / 5
Polubienia
8
Pobrania
46
Wydruki
0
Wyświetlenia
876
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial

The Jayco 242BHS / 242BHSW doesn't have an AC vent in the lower bunk.  It does have an AC vent in the ceiling of the bathroom, but the bathroom is so small that it ends up damn near antarctic in there.  So I made a plenum.  You pop off the vent on the ceiling of the bathroom, print this, put the flange into the ceiling, run it into the wall, and install the former ceiling vent in the wall.  See pictures.

Printed in multiple parts due to the size of the thing.  I used ABS and solvent welded it with acetone together.  There are little tabs on the elbows to help with alignment.  I used a shallow dish with a bit of acetone in it to dip the ends in and then held them together until they stuck.  

Then, I pulled the wall panel off to access the framing. I used caulk and some light foam sheet to insulate the “plenum” area.  Measured and cut a hole for the square plenum in the wall. I also punched a small hole through from the bunk side to locate where to cut the circular hole for the vent.  Nailed the wall panel back on. 

.f3d file also provided if you want to modify.

Tagi