Creality K1 Top Spacer / Raiser back plug
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is an addon for the K1 Top Spacer from Christian K to decrease the hole size on the back.
- Ocena
- 0 / 5
- Polubienia
- 10
- Pobrania
- 77
- Wydruki
- 0
- Wyświetlenia
- 573
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Creality Parts & Upgrades
- Licencja
- Creative Commons — Attribution
As many others, I put the bowden tube of my K1 outside the cable chain and attached it with clips from the outside. I only use the lid for ABS/ASA prints so I searched for a raiser, that is closed and pretty high (so the PTFE doesn't rub on the lid).
I went with the remix from Christian K:
https://www.printables.com/de/model/500361-creality-k1-top-spacer-raiser
The opening on the back (for the bowden tube) is pretty big and as I only use the lid for ABS/ASA, I thought about a way to partially close the back hole without the need to remove the bowden tube.
This is what I came up with. It fits well on my setup by simply sliding it in from the side and then pushing it into the opening.