Raspberry Pi V3 Corner Mount for VZbot 235 AWD
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Moves the camera out of the center of the frame which prevents access to the print bed from the outer doors
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 47
- Wydruki
- 0
- Wyświetlenia
- 369
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Share Alike
UPDATED: 04/12/2024
Added two new files to change the angle of the camera. They are labeled slim as they give better clearance for the HDMI cable. The stock mount doesn't fully show the front of the bed. I recommend using the slim extrusion mount and slim rear mount plate.
04/11/2024
Uses a Raspberry Pi V3 Camera (wide preferred) to mount to the corner extrusion along with a DSI to HDMI cable adapter.
Cable Adapter : Arducam HDMI Adapters : https://www.arducam.com/product/arducam-csi-hdmi-cable-extension-module-15pin-60mm-fpc-cable-raspberry-pi-camera-specific-pack-2-1-set/
HDMI Adapter Mount STL allows mounting of the rear HDMI adapter and use of two sided tape to somewhere near your RPI.
Standard Hardware:
(4) M2 x 10mm bolts or; (4) M2 x 6mm bolts with (4) M2 x 6mm Stand offs.
(2) M3 x 8mm bolts
(6) M3 Heat set inserts
(4) M3 x 30mm bolts
(1) M3 x 8mm bolt & (1) M3 T-Nut (mount has provisions for 2 bolts to be used but 1 is sufficient, two will be difficult to install without a roll in T-Nut on one side.
Special Hardware needed:
You will need a slim HDMI cable with an upward 270. The cable should move back towards the extrusion to allow it to be run down the frame. 2 meters is recommended (1.5 if you can find it). Similar to this design with 4mm cord. (https://www.amazon.nl/-/en/dp/B09XHYQXVG?psc=1&ref=ppx_yo2ov_dt_b_product_details)
Cable mounts provided to run the cable down the extrusion.
Bottom plugs provided to run the cable outside of the enclosure if desired.