Spiral Vase Air Pruning Pot
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A very lazy model, but it prints clean and does the job.
- Ocena
- 5 / 5
- Polubienia
- 35
- Pobrania
- 147
- Wydruki
- 1
- Wyświetlenia
- 799
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor & Garden
- Licencja
- Creative Commons — Public Domain
These parts are designed to use a few solid layers on the bottom and then a continuous and unbroken profile all the way up the part. Prusa and Slic3r call this vase mode, while Cura calls it spiralize.
I was looking for a simple, easy to print air pruning pot and decided to take a little time to make my own. It's a very simple model for spiral vase, with overhangs all over the place that just sort of take care of themselves as it prints. I took inspiration from those ‘fuzzy’ vases they make using ceramic printers.
I've scaled the model by about 25% with success and it should hold up to more. There is also a file for an outer façade in case you would like to plant indoors.
Print Settings
I over-extrude to make them nice and sturdy. You will probably need to bump up your printing temperature by about 5-10°C depending on your wall speeds. I go with 30mm/s and that gets the parts nice and clean within a reasonable timeframe.
Rafts:
No
Supports:
No
Resolution:
0.2mm
Infill:
N/A
Nozzle Diameter:
0.4mm
Line Width:
0.6mm
Top/Bottom Layer Width:
0.4mm
Bottom Layers:
3
Inner/Outer Wall Print Speed:
<30mm/s
Spiralize Outer Contour:
Yup