1 / 9
Cascade wallet V2 - AirTag (Print-in-place) — zdjęcie 1
1 / 9

Cascade wallet V2 - AirTag (Print-in-place)

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Remix of the popular cascade Wallet including provision for Apple AirTag to be snapped into the front.

Ocena
3,5 / 5
Polubienia
26
Pobrania
211
Wydruki
2
Wyświetlenia
1364
Oceny
2

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

A simple addition to add an air tag as I am always putting my wallet down and losing it. 

The air tag simply clicks into the front and has been sunk in to give the slimmest profile. 

Print settings-

0.2mm Layer height 

2 perimeter walls

Quality preset with 15% Gyroid infill

Organic supports were used but the overhang angle turned down to 30 or 35 degrees so just the top of the hole is supported to maintain concentricity. 

There was a small amount of cleanup required due to the small rim that holds the tag in place- just removing some leftovers of the travel moves and small geometry. It is quite a tight fit to ensure that it doesn't fall out in general use.  To remove use a small screwdriver to either lever out from the front or push from inside.