CJMCU-64 (8X8) WS2812 LED grid mounting bracket
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A mounting bracket for generic 64 LED grids with 65x65mm and M2 mounting holes. Used for mounting behind a wall cut out.
- Ocena
- 0 / 5
- Polubienia
- 8
- Pobrania
- 42
- Wydruki
- 0
- Wyświetlenia
- 697
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution
I created this mounting bracket for installing generic 8X8 LED panels which can be bought at Amazon, AliExpress, etc. Check for the dimensions 65x65mm and the three M2 mounting holes at the top and bottom edge of the led panel.
4 recessed holes for M3X12/16 woodscrews are added in the wings to allow mounting the bracket behind the wall cut out.
For fixing the LED panel to the bracket the following additional parts are needed:
- 2X Heat inserts M2X3X3.2
- 2X M2 8mm bolts
- 2X M2 washers
As material I would recommend materials which can withstand a bit higher temps under stress as PLA. I used PETG to print and had great success so far. ABS/ASA should work as well if not better.
Print settings:
Material: PETG
Layer Height: 0.2mm
Walls: 5
Infill: Grid, 20-25%