Cat food can divider - 3 sections
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A simple tool to stamp a pattern into wet cat food to divide it evenly into 1/3s.
- Ocena
- 0 / 5
- Polubienia
- 6
- Pobrania
- 40
- Wydruki
- 0
- Wyświetlenia
- 327
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Pets
- Licencja
- Creative Commons — Attribution — Share Alike
We need to feed our cat 1/3 of a can of wet cat food each meal. You'd think that it'd be easy to figure out every day what ⅓ of a can of food is. But I've found that I'm terrible at geometry. So I made a simple “stamp” to divide a Royal Canin cat food container into thirds. I purposefully did not make it go all the way to the bottom of the container as the cat food would probably stick to this and come out when pulled.
You can use any filament for this but try to make the layers as close together as possible as it goes into food. You WILL need to wash this after every use to ensure bacteria doesn't grow in the layer lines.
I printed in PLA with a 0.6 nozzle and 0.15 layers. But feel free to adapt to your set up.
Inside dimension is 60.5mm and fits in a Royal Canin 5.1oz/145g cat food container.