1 / 1
Netatmo Outdoor Camera 70 degree angle adapter
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Gives you an extra 20 degrees of side-to-side adjustment when aiming your Netatmo Outdoor Camera.
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 19
- Wydruki
- 0
- Wyświetlenia
- 147
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor & Garden
- Licencja
- Creative Commons — Attribution — Share Alike
This adapter gives you another 25 degrees (ish) of side to side aiming ability when installing your Netatmo Outdoor Camera. The factory-supplied bracket can only move 45 degrees to each side of center, which doesn't work for some installations, such as when you are mounting on a wall that is perpendicular to the area you want covered.
It should slide right on to the existing bracket arms, and should match up to the existing mounting holes on the camera and mounting bracket.
Notes:
- You will need a long M4-M5 (or SAE equivalent) bolt to secure the adapter to the factory mounting arms., and probably a couple of slightly longer than original M6 screws for the camera attach points.
- You may need to slightly lengthen the wires coming from the mounting plate - the length of this adapter is right at the edge of the length of the factory supplied wire. My installs did not need this, but it was very close.
- Because this is for outdoor use, it should be printed in a UV resistant material such as ASA, unless you intend to paint it. If you live in a warm location, a material that resists heat well should be used.