Hifiman Headband (Sundara/Ananda etc.)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A TPU headband replacement for Hifiman Ananda/Sundara etc. headphones.
- Ocena
- 0 / 5
- Polubienia
- 6
- Pobrania
- 100
- Wydruki
- 1
- Wyświetlenia
- 2200
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Audio
- Licencja
- Creative Commons — Attribution — Noncommercial
This is a headband model I made for my Hifiman Anandas, it should work for the Sundara as well and all Hifiman headphones with the same type of Head-strap contraption.
You do have to do some disassembly to install it but that should be manageable (As shown in the pictures).
Simply apply some acetone to dissolve the glue holding the silver metal ring on the adjusting part of the Head-strap and pull it down. Now you should simply be able to pull out the metal part attached to the Ear cup and slide off the silver ring, slide on the new headband below the silver ring and push it all back together.
If the old head band is still on you need to pull out the inner part of the black plastic casing to remove it (might take some force as there are plastic clips that hold it together, be careful not to break it though, a prying tool might be helpful).
As for actually printing the thing, it should be pretty straight forward. I used TPU (unknown hardness but likely +-95A) and 0.2mm layer at 100% Infill which worked fine.