1 / 2
Technics SL-3300 or SL-3310 dustcover hinge
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a replacement hinge for Technics SL-3300/3310 when the acrylic tabs break off.
- Ocena
- 0 / 5
- Polubienia
- 6
- Pobrania
- 86
- Wydruki
- 0
- Wyświetlenia
- 541
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Mechanical Parts
- Licencja
- Creative Commons — Attribution
This is the upper part hinge, to replace the acrylic tabs when they break on Technics SL-3300 turntable.
Might fit other Technics turntables with tabs molded into the dustcover. Please post in the comments if you used this on another model.
To install the replacement hinge, the tabs need to be cut from the dustcover
List of materials for replacing both hinges
- 3D printed hinges
- 4 x M3.5 x 20mm screws
- 8 x M4 washers
I've printed mine in PETG on an Ender3 v2 with 20% infill and they seem to be holding well so far.
Instructions:
- 3D print replacement hinges
- grind off the acrylic tabs using a dremel. The outer surface around the old tabs needs to be as smooth as possible.
- after grinding, cover the tabs place with masking tape for marking
- tape down the dustcover with masking tape in the expected position, carefully aligning it to the back of the turntable and ensuring an even gap to the sides
- install the hinge into the base and rotate it towards the dustcover.
- when it touches the dustcover, mark the holes
- drill the holes in the acrylic lid. Go slow here as the acrylic can crack easily.
- remove the masking tape and screw in the hinges
- install the dust cover into the base brackets