1 / 4
Magnetic Dust Shoe 80mm simple shop vac — zdjęcie 1
1 / 4

Magnetic Dust Shoe 80mm simple shop vac

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Dust shoe for 80mm spindle, small in size for smaller machines for anything over 1mtr squre I would choose a 100mm…

Ocena
0 / 5
Polubienia
3
Pobrania
30
Wydruki
0
Wyświetlenia
479
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Tools
Licencja
Creative Commons — Attribution — Noncommercial

Dust shoe for 80mm spindle, small in size for smaller machines for anything over 1mtr squre I would choose a 100mm rather than a 35mm extraction port.

Print Settings

Printer Brand:

Creality

Printer:

K1

Rafts:

No

Supports:

Doesn't Matter

Resolution:

0.2 - 0.4

Infill:

50%

Filament: ANY ABS PLA TPU ANY


Notes:

I used supports for bottom on sloping input inside & out, manual tree allowed minimal supports, inner supports were unnecessary, so outside should be sufficient.

I used ABS, however any filament may be used but take into consideration both heat & how brittlle PLa may be if run into objects on CNC bed, my cheap chinese water cooled 2.2kw does not usually exceed ambient room temperature some air cooled spindles may.

TPU WOULD BE THE VIRTUALY INDESTRUCTABLE CHOICE...

Post-Printing

Adding magnets

The magnets are a tight fit, I also secure with super glue.

after applying super glue to hole I use stack of magnets pushing part way in and sliding stack off, then I press fit with clamp or soft jawed vice to sit them level with surface.

Be aware of polarity of magnets insert all same way on first part, then attach stack of magnets to one of those remove and reverse stack before repeating on second part, they tend to be unremovable in seconds so correcting polarity as an after thought not an option.

Base has slot to insert brissles or strips of vynil to create flexible air seak, presonaly I use cheap or old brush cutting off brissles, which I push into silicone previously applied to slot. the premade strip brush solutions tend to be expensive another alternative depending on length required may be draft excluder brushes used on bottoms of doors.

How I Designed This

Designed in Fusion 360 for shop vac powered cyclonic dust collector 35mm hose connection.

Trying out Fusion 360 you may notice inconsistencies in design of two parts, the fit together perfectly but as a learning exercise more interested in trying features and producing useable item than carrying through theme one rounded other more angular.

Category: Tools

Tagi