Hercules Inpulse 500 Deck Riser Feet
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is just a simple feet I designed to raise my dj deck to be more comfortably.
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 32
- Wydruki
- 0
- Wyświetlenia
- 270
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Audio
- Licencja
- Creative Commons — Attribution — Noncommercial
It snuggly fits to the feet of a Hercules Inpulse 500, even when you lift the deck, the feet stay on.
You have to push them on at a slight angle, kind of counter-intuitive, but I promise they hold fine afterwards.
Print it with any settings you like, I mean I printed it with 0.6mm layer height on a 0.8mm nozzle for tests and 0.4mm layer height for the final version.
Any material probably works, but it benefits from being a hard material, since it squeezes the rubber feet of the deck a bit. So PLA is probably better than PETG.
Feet are wide and very stable. The plastic of course slips on the table. Maybe add some rubber pads underneath. I use some tiny piece of double sided tape.
Not for commercial use.