The 100 V1.1 Orbiter 2.0 mount

Remixed from: https://www.printables.com/model/719492-orbiter-20-extruder-mount-for-the-100-v11-v04

Details (ripped from original model description, [ ] indicates changed or added lines):

"

BOM

• [ 8 ea. M3x8 SHCS ]
• 1 ea. PC4-M10 pneumatic fitting
• [ 2ea. M3x4 heat-set inserts ]

Tools

• 2.5 mm hex key
• Ratchet with 10mm socket and extension (bonus for using a deep socket)
• [ Soldering Iron ]

Print settings:

• 0.2 layer height (0.3 first layer)
• 0.5 width
• ironing “all top surfaces” (optional)
• 5 walls
• 5 top
• 5 bottom
• 20% infill (I used cubic)
• no supports

Instructions

1. Print the bracket
2. Using the 10mm socket and ratchet, squarely drive the PC4-M10 fitting into the round hole that has a diameter of 10mm until it is firmly tightened. Careful to not strip it.
3. Using the 2.5 mm hex key, mount the bracket to the extruder mounting point on the top-back of the printer with 6 ea. of the M3x8 screws. Don't use the hole that's now blocked by the PC4-M10 fitting (top center). Don't strip the heatset inserts.
4. [ Using the Soldering Iron, insert the 2 M3x4 heat-set inserts into the two extruder mounting holes. ]
5. [ Screw the extruder into the underside of the mount with the motor facing outwards using 2 ea. of the M3x8 screws ]

"