1 / 2
ARZOPA S1 to VESA to French Cleat Holder
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
this is a very lightweight ARZOPA to VESA 100x100 Mount and added a French Cleat Holder for my Workshop :)
- Ocena
- 0 / 5
- Polubienia
- 16
- Pobrania
- 154
- Wydruki
- 0
- Wyświetlenia
- 1371
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
SzczegółyPliki (3)Wydruki i komentarze (Wydruki: 0) (Komentarze: 0)Remiksy (1)Kolekcje (26)Powiązane
Print without Support fully in about 2:30h
you need 4 M4 Nuts and 4x M4x16mm Screws for mounting, you can add longer screws to adjust the angle - then you only should extend the “abstandshalter”