Lamp #1
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A simple 2 piece lamp. easy to print. Plug into mains, shown with German plug. 210 mm by 85 mm
- Ocena
- 0 / 5
- Polubienia
- 23
- Pobrania
- 108
- Wydruki
- 0
- Wyświetlenia
- 509
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Home Decor
- Licencja
- Creative Commons — Attribution — Noncommercial
This is a simple lamp, easy to print in 2 pieces. The outer Shell and an inner shade.
210 mm Height - 85 mm width
It was made for an E14 fassung(socket) with a threaded insert printed to make it easier to screw in the bulb socket . The bulb is a low wattage soft white.
The filaments used were an ERYONE Matte PLA Filament black and Prusament Vanilla White for the shade. No supports are required during printing.
The electrical parts are listed cheaply available.
The electrical parts are pictured and cheaply available.
The fassung-lamp socket ( e14-28 mm):
https://www.amazon.de/dp/B097K4YNL9
The electrical cable and switch:
https://www.amazon.de/dp/B002DAOX58
The E14 Bulb used here:
https://www.amazon.de/dp/B0B5MPL9MX
The slicer settings for the outer shell:
.20 mm Standard and Generic PLA
(All standard settings and speeds)
Filament: Eryone Matte Black PLA
The slicer settings for the Bullet Shade:
.16 mm High Quality and Generic PLA
Infill % - 30 , Gyroid
Wall Loops - 8
Top Shell - 8
Bottom Shell - 6
Outer Wall Speed - 60 mm/s
Inner Wall - 150 mm/s
Seam Position- Random
Filament- Prusament Vanilla White