PIoreactor vial cap for electrolysis and CO2 sparging
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Cap with six holes that fits 20ml vial
- Ocena
- 5 / 5
- Polubienia
- 6
- Pobrania
- 23
- Wydruki
- 0
- Wyświetlenia
- 325
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Chemistry & Biology
- Licencja
- Creative Commons — Attribution
This cap has six holes so that you can insert electrodes for in-situ electrolysis and lines for CO2 sparging, in addition to the inflow/outflow lines.
There are two different designs with the holes in different orientations.
A special thank you to Rob Jess for creating this design!
Printing
Important: only use high-temperature plastics if you plan to heat-sterilize this cap. We use Prusa's Polycarbonate and Polycarbonate-CF
- 3 vertical shell perimeters
- 0.15mm layer height
- Print with the top-side down for best results
Adding an o-ring insert underneath
To avoid leaks, we add a 1/16" W, 3/4" ID, 7/8" OD o-ring underneath. It's secured with some high-temperature silicone. Tip: we put the uncured silicone into a syringe to apply.