Combined Sexbolt and Klicky probe mount for Ender style beds

(For use with Voron Sexbolt kit parts, also print these adapter parts)

What are klicky and sexbolt? 

klicky is a magnetic probe that attaches to your toolhead for bed probing. It is lower profile than a bltouch, so it can mount much closer to the nozzle for a larger effective mesh size 

sexbolt is a metallised z endstop that allows you to home onto it with your nozzle. When used with automatic z calibration, it can be used to calculate your z offset automatically.

 

Whats so special about this design, compared to alternatives?

• Very rigid. uses a corner shaped design and clamps to the underside and top edge of the bed to reduce flex. Most other designs depend on the plastic for rigidity.
• Corner stop for easy bed alignment
• Constant offset between the bed and the mount, regardless of bed spring adjustment. This is important because bed slingers often dont have enough X space for the toolhead to completely clear the print bed. 
• No additional gcode required for probe mounting
• Y movement undocks the probe. Compared to options like klackender, this ensures you cannot possibly crash your nozzle against the bed when undocking the probe
• Auto Z Offset compatible (on a bedslinger, only bed mounted sexbolts can be used for auto z offset)

Since the klicky dock and sexbolt are mounted together, there is not separate gcode needed to pick up the probe. However, you must ensure the distance between your sexbolt and klicky dock is correct for your toolhead. This mount has been designed for that, you can adjust the x and z distance between the two by using washers. the default spacing is sized for Armchair engineering's Archetype Mjolnir.
If you want to use Archetype toolhead on an Ender style X gantry, you can do so with my mounting parts here

BOM:

• sexbolt
  • Stock z endstop (tested with Ender 3 z endstop but should fit most)
  • 1 M4 Sexbolt (aka bookbinding screw)
  • 1 M4 Grub screw (this is to fill the hole in the sexbolt)
  • (optional) 5mm ID copper ferrule (makeshift bushing for smoother movement)
  • 2 M3x10 screws
  • 2 M3x4 5mm head screws or M3x12 screw (need to print 2x bolt spacer to clear the z endstop JST XH connector)
• klicky + dock
  • 4 3x2mm cylinder magnets
  • standard PCB Klicky kit (pcb, switch, magnets)
  • 1 M3x16 screw
  • 1 M3x10 screw (must be buttonhead or flat head to sit flush in the dock)
• mount
  • 19 M3 heatsets
  • 3 M3x32 screws
  • 6 M3x10 screws
  • 2 M3 washers & 2 M3x4 screws, or 2 M3x4 widehead screws

Sample Docking & Undocking config in \_klicky.txt (rename to \_klicky.cfg, then add “[include _klicky.cfg]” to your printer config. Kalico required.)