1 / 4
3D printable parts for custom acrylic enclosure for Creality Ender 3 V3 KE — zdjęcie 1
1 / 4

3D printable parts for custom acrylic enclosure for Creality Ender 3 V3 KE

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Just the 3D printable parts to go with assembly for the custom acrylic enclosure for the Ender 3 V3 KE.

Ocena
0 / 5
Polubienia
129
Pobrania
397
Wydruki
0
Wyświetlenia
5004
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Public Domain

Inspired by u/bringmedavid ‘s Reddit post for their Ender 3 V2 enclosure https://www.reddit.com/r/3Dprinting/s/NG5MuPpwxt with some modifications made to some of the parts and size difference to accommodate my V3.

My original post: https://www.reddit.com/r/Ender3V3KE/s/J1Xeihcn1V

I decided to add a small side door for easy access to the touch pad which turned out to be a great addition to have after using it a couple times. The transparent acrylic sheets were cut to size using a circular saw and bolted onto the structural corner brackets and mid-brackets. The brackets were fastened to the 1” wood boards using an assortment of wood screws and a power drill.

The wood boards are 1"x1" cross section composed of lengths qty. 4x - 30.125" for the vertical, qty. 4x 19.375" for the sides (left/right), qty. 4x 18.125" for the front/back.

All bolts are ¼" bolts with nuts, and with ¼" washers. All screws are either #4 for small holes or #8 for larger holes.

The acrylic sheets OD are 19.25"x28" for the sides, 18"x28" for the back, qty. 2 - 8-15/16"x28" for the two front door panels. The clearance is designed to be 1/16" all around between the acrylic sheets and the wood boards when assembled.

I recommend to use a circular saw to cut the acrylic sheets to size and a power drill for fastening screws and drilling holes for bolts. I used an Avanti 5-½" x100T Carbide blade for my 5-½" circular saw and the cuts came out perfect. Use a contractor's grade masking tape to cover the acrylic sheets on the parts where it's to be sawed/drilled into. I used a standard carbide steel drill bit, but you will need to drill very slowly otherwise there is a chance the acrylic will crack if drilling too fast. I also recommended to mark with a marker the location of the drilled holes and first drill a 1/16" pilot hole before attempting to drill the larger hole for the ¼" bolts. I used a 3/8" drill bit to give myself some room for error. Washers are recommended when fastening the bolts to increase surface area contact.