Hyperpixel (with Pi Zero) Enclosure and Mount
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is an enclosure designed for the Pimoroni Hyperpixel 4.0, with a Raspberry Pi Zero attached.
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 14
- Wydruki
- 0
- Wyświetlenia
- 214
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Attribution — Noncommercial
I've been using the touch-enabled version of the Pimoroni Hyperpixel (with Octodash) in this enclosure for several years, and I built an updated version for the MK4. (I have this installed on the left side of the printer, though it could just as easily be installed on the right.)
The Display Assembly is attached to the Mount with two small magnets, which allow it to be rotated for a better viewing angle (or moved out of the way should filament need to be loaded on the Spool Holder).
The Hyperpixel is installed slightly off-center in the enclosure, so the display image will appear to be centered when the frame is attached.
Files and Notes:
- The Bracket clips on to the printer frame. There is space on the back for a small nut to be inserted.
- The Mount Extend attaches to the Bracket with a machine screw. The channel will allow for the angle and height to be adjusted. (There is also a clip on the back to secure the power cable for the Pi Zero.)
- The Mount attaches to the Mount Extend with a cap screw and locking nut, and has space for a 12 x 3 mm magnet in the center, at the top. (Secure that with a small amount of glue.)
- The Assembly Ring fits into the circle on the bottom of the Display Assembly, attached with a small amount of glue. The top of the Mount will fit into this. (I found that printing the Assembly Ring separately provided a smoother surface for rotating the Display, one that I wasn't able to achieve printing it in place with supports.)
- The Display Assembly has space for a 12 x 3 mm magnet in the bottom (secure that with a small amount of glue). This is used to attach it to the Mount, and allows it to be rotated.
- The Display Assembly Frame fits on the front of the Display Assembly.
Hardware you'll need:
Two 12 x 3 mm Neodymium Magnets. I used these parts I had on hand: 1/4-inch-20 x 5/8-inch Machine Screw, 1/4-inch-20 Nut, M5 x 20 Socket Head Cap Screw and Locking Nut. Similar parts could also work.
I printed most of the parts in ABS (except for the Display Assembly Frame, that looks especially sharp in Prusament Galaxy Black PLA), using a 0.4mm nozzle / 0.2mm layer height with default PrusaSlicer settings. (Supports were not necessary.)
It might be useful to print the Bracket, Mount Extend and Display Mount with additional perimeters, as they have hardware that will need to be tightened down a bit.