MK4 Display underside mount
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Simple model for if you want to mount your Prusa MK4 display on the UNDERside of your enclosure
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 17
- Wydruki
- 0
- Wyświetlenia
- 176
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Prusa Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial
I made a simple enclosure for my MK4, based on an IKEA Platsa cabinet (great tip btw). I put the entire enclosure on tall feet, so that I can put some stuff underneath, like drawers or tools.
To make sure the door can close and there is enough room at the back for the bed to move, I changed the position of the display to under the enclosure. That way you can also control your printer without opening the door.
Installation
- Disconnect display cable and grounding cable
- Remove the cables from all cable guides on the printer frame
- Make a hole in the bottom of your enclosure directly below the xBuddy case (big enough to fit the display connector through)
- Route the cables through the hole and under your enclosure
- Mount the bracket where you want it (I suggest centered, but I won't judge), use two dome-head or pin-head screws.
- Don't use countersunk screws, they will break the mounting bracket.
- Mount the display to the mount with the original m3 bolts
- Reconnect the cables
Printing
I printed in PETG, with 4 perimeters, top and bottom layers, but honestly I think that PLA will work just fine. Since you put it on the outside of the enclosure, the temperatures are not going to be that high usually.