Ender 3v2 Neo Riser Feet 25mm & 35mm
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Riser feet for Ender 3v2 Neo that make the printer sit higher of the ground for more airflow underneath the printer.
- Ocena
- 4 / 5
- Polubienia
- 16
- Pobrania
- 121
- Wydruki
- 1
- Wyświetlenia
- 443
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Creality Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial
Riser feet for Ender 3v2 Neo that make the printer sit higher of the ground for more airflow underneath. This part makes use of the OEM rubber feet that come with the printer so no cutting or other permanent modifications have to be made.
The feet raise the printer a total of 25mm of the ground (15mm more than the original setup) allowing for more than enough room to install a Noctua fan upgrade on the PSU and motherboard.
The Ender 3v2 Neo has slightly bigger rubber feet than the ender 3v2 (1mm difference) making the normal 3v2 riser feet not fit on the Neo.
You will need to print a total of 4 feet for your printer. For the least amount of supports and the cleanest print, parts should be printed laying on their side. If you are confident in your overhang performance you can also try printing the parts without support.
25/05/2026 - Added a 35mm variant (raising the printer 25mm more than the original setup)