Wheel Mount for Electrolux Dishwashers
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Replacement wheel mount for dishwashers made by the Electrolux brand group: Progress, Zanussi, AEG, Zanker, Juno...
- Ocena
- 5 / 5
- Polubienia
- 8
- Pobrania
- 81
- Wydruki
- 1
- Wyświetlenia
- 318
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Kitchen
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This model replaces the wheel mounts used in most dishwashers made by the Electrolux brand group. This includes dishwashers by brands like AEG, Progress, Zanker, Zanussi, Juno, Frigidaire, Kelvinator and also some dishwasher sold at IKEA.
Printing
Print in the STL's original orientation:
Supports: none
Brim: 2mm worked for me (v2, v1 didn't require any brim)
Perimeters: 4 work best with a 0.4 nozzle
Material: Preferably ASA, ABS or other sufficiently heat resistant material. DO NOT PRINT IN PLA OR PETG. Those will not last a single wash cycle.
Changelog
Update 1 (v2)
Due to the orientation of the layer lines in v1, some of the wheel mounts snapped after about a year in use. In v2 I cut off the corner to create a new face that should be used as the new bottom face. This rotates the layer lines by 45° degrees, which should make the ‘axle’ part (where the wheel snaps on) much stronger. However, a bit of brim is required now, because the new bottom face is rather small.