1 / 4
120mm fan solder fume extractor, USB-C — zdjęcie 1
1 / 4

120mm fan solder fume extractor, USB-C

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Solder fume extractor with 120mm fan, USB-C power, and 130mm carbon filter. Snap-fit design, no tools needed.

Ocena
4 / 5
Polubienia
20
Pobrania
87
Wydruki
0
Wyświetlenia
1110
Oceny
1

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Electronics
Licencja
GNU General Public License v2.0

This solder fume extractor utilizes a 120mm PC fan to extract fumes and direct them through a replaceable 130mm activated carbon filter.

The extractor is powered via a USB-C port and is compatible with any USB-PD charger capable of providing more than 12 volts.

The model consists of three parts designed to snap-fit together, eliminating the need for additional tools or hardware during assembly.

Bill of Materials:

The following components are required to build a fume extractor using this model:

Print Instructions:

All three parts were printed using Prusament PLA on a Prusa MK4. The provided .3mf files are oriented to allow for printing without the need of support materials.

Assembly Instructions:

Begin by preparing the electronics.

  1. Solder the jumper wires to the pads of USB-C decoy module.
    • If using a variable voltage USB-C decoy, ensure that correct resistor is shorted to obtain 12V from the modulle.
  2. Connect the wires to the appropriate port on the PC fan.
    • If you're using 4-pin NOCTUA fan, connect a positive wire to the fan's yellow wire and the ground wire to the fan's black wire.
  3. Connect the assembled parts to a USB-PD charger and verify that the fan is operational.

Next, integrate the electronics with the printed parts:

  1. Position the electronics on the BackBodyBottom part. Wrap the fan's cable around the fan to minimize loose wiring. Ensure that the fan is oriented correctly, with the air blowing towards the circular hole in the bottom part.
  2. Secure the assembly by attaching the BackBodyTop part.
  3. Place a 130mm carbon filter on the FrontCover part.
  4. Insert the assembled BackBody parts to the front cover.

Finally, if you wish to mount the extractor on a tripod, install the threaded insert to the hole located adjacent to the USB-C port.

Tagi