Nexus Pro X Barrel Collet Frontend
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A quick change frontend for the Nexus Pro X
- Ocena
- 5 / 5
- Polubienia
- 52
- Pobrania
- 405
- Wydruki
- 6
- Wyświetlenia
- 1636
- Oceny
- 3
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor Toys
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
For use with any other collet in the ecosystem (Xshot Longshot, Unicorn)
Printable with no support, if the overhang is giving some problems, you can use some. This is functional with the stock barrel. The stock barrel measures (incase you were interested): 19cm long, 13mm ID, 15.95mm OD.
To install, Open the blaster, remove the screws (from both sides) holding in the frontend, and remove it. Then slide the new one in (without collet installed), screw in the 4 screws (2 on each side). Insert your barrel, and tighten the collet.
The “Faux Gas Block” One has a fake tube on the top
Don't have a printer? Order from OOD! Affiliate link!