1 / 3
Kirby Solder Fume Extractor — zdjęcie 1
1 / 3

Kirby Solder Fume Extractor

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

A Kirby Fume extractor that is powered by a 9V battery/wall power

Ocena
0 / 5
Polubienia
12
Pobrania
49
Wydruki
0
Wyświetlenia
784
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial

This is a 3D printable kirby fume extractor that took inspiration from Chris Borge's kirby fume extractor. A few parts like the hinge that allows the kirby to turn up and down was taken from his design and I recommend checking it out. I took my own spin on it for my own purpose and made it so that it ran on a 9v battery instead of wall power. This is less voltage than the limit of 12v that the fan I used is rated for however the suction should still be pretty good for soldering.


Edit: added wallpower design

 

The kirby is designed to specifically house the following parts:

Battery Powered:

Fan

Switch

Battery Connector

Wall Power:

Female Power Jack

 

Some assembly is required but it should mainly be self explanatory. The screws that come with the fan are required to keep the front and back ends of the kirby together. The grate is intended to be glued to the back as well as the feet to the star and the cheeks and eyes. The only thing connecting the kirby to the star itself is the hinge connector which is able to be slid on through the bottom of the kirby. Some soldering/connecting of wires is required and is done in the hole of the right foot. You will probably need to cut some of the wires down to size so it all fits neatly in. The front end of the kirby has space for a filter to be placed.

I printed the kirby with a variety of different filament colors and spray painted some of the other parts to color. Filament type shouldn't matter too much however I did find that the battery panel was a bit bendy, so a tougher filament that's less flexible may be bettter.

There are two versions one wall powered and one battery powered. The only difference between the two are the feet and the star. The fan is rated for 12v dc.
 

I'm a highschooler who likes to make and design stuff in his free time so I hope you enjoy! If you have any questions on assembly or any feedback on the design, feel free to email me at [email protected]

Tagi