Seven Segment Display (24 hour version)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A variation of my seven segment display with 24 stops in one rotation
- Ocena
- 5 / 5
- Polubienia
- 108
- Pobrania
- 300
- Wydruki
- 1
- Wyświetlenia
- 2835
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Engineering
- Licencja
- Creative Commons — Attribution
This is a mechanical seven segment display that counts from 0 to 23 using a camshaft.
It will show this pattern of numbers during one rotation:
0, 1, 2, 3, 4, 5, 6, 7, 8, 9, 0, 1, 2, 3, 4, 5, 6, 7, 8, 9, 0, 1, 2, 3
This is specifically designed to be a component of a 24-hour clock. If you want a regular seven segment display, make this one instead.
Non-printed parts
- 8x Square M3 Nuts
- 4x M3x6 screws (or longer)
- Plastic glue
Printed parts
- 1x Front plate
- 2x Side plate
- 2x Top/Bottom Plate
- 7x Segment
- 2x Pusher Right
- 2x Pusher Left
- 3x Pusher Center
- 7x Pusher Pin
- 1x Camshaft
The parts marked with a ★ are shared with the regular size seven segment display.
Printing
The camshaft should be printed standing up with supports. Everything else can be printed laying flat without supports.
Assembly
Assembly
- Insert four square M3 nuts into the front plate and glue them into place
- Put a pusher pin into each pusher plate and glue it in place.
- Connect a segment to each pusher as shown in the photo.
- Put the segments into the front plate.
- Attach the side plate on the side where the pushers don't have an opening and screw it into place.
- Optional: Insert square M3 nuts into the top and bottom plate and glue them into place. The nuts can be used later to attach other things to the seven segment display.
- Place the camshaft between the top and bottom plate and insert these pieces into the unit.
- Attach the other side plate and screw it into place.
- Attach the knob.
