Parametric Washer Stamping Jig

This model takes the essence of previouse stamping jigs like Blockmit's but improves them and makes it ultra 3d printable:

• a little notch on every part provides a place to put seams in. Make sure your slicer's setting for “Z Seam Alignment” is set to “Sharpest Corner”. This makes sure, that no seam prevents the parts from fitting
• the bottom is chamfered to minimize the effect of elephant's foot
• the middle part of the jig is extra long and sturdy, so the metal stamp has more support and can't tilt as much
• the outer part can be easily and securely hold thanks to the big fillet

The uploaded STL is made for ISO 7093 M8 washers and quadratic 6 mm punch stamps. If you need somehting different you can modify the model through variables in onshape. 

Note: You need a free account for that.

If you want to tip me some sats