Honeycomb Storage Wall - Gunpla Display Arms
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A set of Honeycomb Storage Wall components to hold HG Gunpla, or other models that can fit a ~1.9mm peg.
- Ocena
- 0 / 5
- Polubienia
- 25
- Pobrania
- 92
- Wydruki
- 1
- Wyświetlenia
- 902
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Organizers
- Licencja
- Creative Commons — Attribution — Noncommercial
I found myself with a large pile of HG kits to build and not enough shelf space to display them, so I turned to the obvious solution: Honeycomb Storage Wall!
I designed these to print flat on the build plate with no support and in a way the provides optimum strength. To this end, the arms are composed of two parts, the Display Arm itself, and the peg that supports the model.
The arms come in four lengths, labeled A, B, C, and D, with A being the shortest and D being the longest. Each has a recessed hole to insert a peg, these are available in 5 different angles in 15° increments from angled back at 15° to angled forward at 45°. These should accommodate a range of poses.
Like the arms, the pegs come in four sizes, A, B, C, and D from shortest to longest. They also print flat on the bed, the pin that inserts into the model has a tapered end. If you find the pin is too lose to fit securely in a model, you can trim a few mm off the tip and try again. I find 2-3 mm is usually enough to make a secure fit. An OpenSCAD model is included so you can adjust these to fit. The pegs should be glued into the chosen arm and the entire assembly can then be inserted into a HSW hollow insert, it should fit snugly and securely.