9mm Ammo Case 100 rnds

This is my 100 round case in 9mm. I tried this to demonstrate a new hinge assembly and because of the size I had to print base and lid separately. You will see my demo hinge, in orange, that I printed, to test the design. I scaled the hinge up from my previous designs to add some strength to the assembly.

I have shown the lid through stages as well a picture of the extra items you will require to complete the moving parts. I have added some addition stiffeners to the insert, as I was not happy with the first print. The image of the case includes the insert from my first print anyway as it still works ok. I have lowered the insert from the first 9mm case I did as the spent shells got lost in the insert. 

There is a gasket in the lid to seal the box from outside air, it's made with TPU 95. The case and components are PLA.

The springs are 18mm long x 7mm diameter and 0.5mm section thickness. The shafts for the latch assembly are 1.6mm ( 1/16" x 1-1/2" length) finish nails, you will have to clip them to length.

Assembling the hinges will require a bit of patience, but on a flat workspace the hinge sections mesh together, you can partially assemble and insert one hinge and then rotate the other assembled hinge in place and push together till they align.

I printed the components with Bambu Labs X1E.  The lid and case are about 3 hrs each and the insert is about 7hrs, I printed the latch and hinge assembly separately, because they are so small the pieces on occasion fall over and I don't want to ruin the large prints. 

As always please comment, likes or dislikes, as I am happy to improve the design if required.

Happy shooting, campers.