Lens Cover Remover for Insta360 x4
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
When I got my Insta360 x4 I was happy to receive also the protective lens cover. When attaching it I realized, this is…
- Ocena
- 4,875 / 5
- Polubienia
- 94
- Pobrania
- 621
- Wydruki
- 11
- Wyświetlenia
- 1963
- Oceny
- 8
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Photo & Video
- Licencja
- Creative Commons — Attribution — Noncommercial
Update:
I added a v2 version which should fit a bit better. Also made it a bit bigger for better usage.
When I got my Insta360 x4 I was happy to receive also the protective lens cover. When attaching it I realized, this is made for smaller hands than mine. I had my problems putting it in the right place and espacially locking it in place as I could not get a grip on the very small ring at the lower end.
I created this little helper in TinkerCAD and hope it helps also others. I put cover in place and use the tool to lock it in place, same goes obviously for unlocking it.
No special print setting necessary, do not use brims or rafts, and be sure to have a good bed adhesion instead.
15% infill was sufficient for my use.
Print Settings
Printer Brand:
Creality
Printer:
Ender-3 V2 Neo
Rafts:
No
Supports:
No
Resolution:
0.4
Infill:
15
Category: Camera