2.5" disk holder for Standard Pi-4 Touch-Screen Case
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Holder for 2.5" disks for use in a Standard Pi-4 Touch-Screen Case by One Nine Manufacturing Ltd
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 8
- Wydruki
- 0
- Wyświetlenia
- 85
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Portable Devices
- Licencja
- Creative Commons — Attribution — Noncommercial
An ugly-but-functional holder for 2.5" disks for use in One Nine Manufacturing Ltd's Standard Pi-4 Touch-Screen Case instead of the standard snap-on back cover.
Instructions: print two copies, mirroring one. Print with the side facing down and the angled tip facing away from the print bed. Minimal supports needed. Use the de-digitizer (aka. digit remover aka. darned sharp knife) supplied with your printer to remove non-smooth pieces, or use a filament that doesn't ooze.
The unit in the photo was printed with an oozing filament, colorFabb's allPHA, and minimal knife-usage was required.
The aim is to provide a functional product, not a pretty one. Tested to work with 0.6 nozzle, 0.15 layer height and allPHA natural.
FreeCAD design available on request.