1 / 3
Phillips Steamglide Elite Iron - Clip on cord holder and base extender — zdjęcie 1
1 / 3

Phillips Steamglide Elite Iron - Clip on cord holder and base extender

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

I was fed up with this expensive iron having no design consideration for cord storage or stability of the iron

Ocena
0 / 5
Polubienia
2
Pobrania
18
Wydruki
0
Wyświetlenia
202
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Kitchen
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

Clip on base extender and cord storage for the Phillips Steamglide Elite iron.   

Printed in PETG with 4 walls and 10% 3d honeycomb infill.  No supports used but my slicer profile has been tuned for overhangs.

This is designed for a tight clip on fit.  Slide the iron onto the tow front pegs at an angle and then press the iron down into the base until it clicks.  The rear peg clips into the cord hole.

To remove the base, just grip the lip near the cord and gently pull down and away.   

Update:  Beefed up the prongs as my teenage son did some destruction testing, twice….

The Step file shows a “non-manifold edges” error when loaded into Orca but I dont have time to work out why.  Just hit repair and it rebuilds and prints fine.  Stl and 3mf versions as well

Tagi