HSW Needle and Thread holder Sewing Kit (Honeycomb Storage Wall)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
3d printed pin cushion and storage for just a few spools.
- Ocena
- 0 / 5
- Polubienia
- 18
- Pobrania
- 75
- Wydruki
- 0
- Wyświetlenia
- 697
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Organizers
- Licencja
- Creative Commons — Attribution — Noncommercial
I just needed a simple place to put a few spools of thread and some needles. This is all for practical stuff, I don't care if the thread color matches so I don't need a bunch of different colors and I want to be able to store a few needles as well.
This is for what I assume are fairly standard spools, 36mm diameter and 43mm tall. Not the really tiny travel ones, but the ones I often see on sewing machines.
Didn't see anything quite like it so I made this.
I made three versions for 1 - 3 spools of thread depending on what you need.
The cube for the pin cushion is 30mm cubed.
I included a simple 30mm cube that can be 3d printed in TPU with about 15 percent gyroid infill (cubic should work too) and the top layer turned off. Or you can just make the 30mm cube as a shape in the slicer itself.
You could also cut out some foam or Styrofoam and glue it in there and that would probably work even better.
I don't have any foam right at hand so just printed it in TPU and it works surprisingly well.