GraveDigger - TPU 3D-printed shoes
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
WARNING: This is not a dialed-in, well tested print.
- Ocena
- 0 / 5
- Polubienia
- 111
- Pobrania
- 294
- Wydruki
- 0
- Wyświetlenia
- 13 134
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Men
- Licencja
- Creative Commons — Attribution — Noncommercial
I made these shoes as a project while I learned grasshopper. Proceed at your own risk. They're not comfortable, and you may break your ankle in them.
The design is a TPU torture test for your printer (I used Shore 95A-ish). My unmodified MK3S did fine, not sure how yours will perform.
Expect to print them a few times and spend 6+ hours with assembly/cleanup.
- Uppers: TPU:
- Use Prusaslicer's paint on support to put a little support dot on each post.
- You may have to turn/adjust the shoe to get it to fit in a mk3s build envelope.
- I did need support for the upper surface of each foot (see pictures).
- Used a soldering iron to punch in shoelaces holes as desired.
- Also had to use the soldering iron to smooth out the inner surfaces to the TPU blobs wouldn't cut my foot.
- Lowers (TPU):
- Paint a support onto just the bottom surface so it will stick.
- Sole (PLA):
- Don't print it solid. I used 3 x 0.4mm perimeters with a 15% gyroid infill.
- Support in the 3 areas highlighted in the images.
- Tread (TPU):
- Nothing fancy here, had to clean it up with a hobby knife to get some pegs to fit.
- Insole: (TPU):
- 13 percent gyroid infill, you may have to tweak based on body weight. You want it pretty stiff.
- Printed in the orientation shown (don't let the support onto the angled edges, or you'll never get it off and it won't fit in the PLA sole.
- Removing this support was a bear and messed up the bottom surface, but you'll never see it.
- Shoelaces: 1/8 thin waxed shoelace, I used these from Amazon. They weren't an exact color match: VSUDO Waxed Round Shoelaces, 1/8" Thick Shoe Laces for Oxford or Dress Shoes (2 Pairs-Yellow-140CM)
- Mirror everything to get right/left pairs.
- Sizing (appx): See the image for international sizes.
- 8.5 US womens
- 12 US mens
To assemble, glue everything in place with superglue.
Don't make anyone else wear these, and don't be surprised when they're not comfortable.
If you make a pair, please take a picture/video and post it. I'd love to see how they turned out.