4mm bit screwdriver - magnet, rotating end, 2 bit storage.
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Small screwdriver with bit holder (2 bits), magnet to hold inserted bit and moving back to ease screwing.
- Ocena
- 0 / 5
- Polubienia
- 4
- Pobrania
- 25
- Wydruki
- 0
- Wyświetlenia
- 163
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
21.05.2024 - updated with step and f3d files ;)
I've searched lots of internet and found nothing similar what I needed.
So I made it :)
A screwdriver for 4mm bits with bit holder and rotating back to ease screwing.
Additional things needed:
- 5x4mm magnet (diameter/height)
- little lube
- leftover filament
- superglue
For printing body You will need brim - i used 8-10mm depending speeds. Anything else should print fine without anything. No supports needed.
4 perimeters and 30% infil, but it should work fine with lower ones :)
Some instructions for assembly:
- Add lube into cap where “rotating back” slots in. (One side has thread, one does not. Lube one with no thread)
2. Insert “rotating end” into cap and secure it with leftover filament.
3. Cut filament as close to faces as possible.
4. Add a magnet to body using superglue and assemble everything ;)
Please share with me what is wrong with model and I'll try to fix it :)
Also don't forget to share a make and a heart if You like it :D