Milk Bag Jug Holder
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Why buy 2 litres of milk for $5 when you can buy 4L for $5? Probably because you don't have this bag holder...yet...
- Ocena
- 5 / 5
- Polubienia
- 20
- Pobrania
- 318
- Wydruki
- 2
- Wyświetlenia
- 1383
- Oceny
- 2
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Kitchen
- Licencja
- Creative Commons — Attribution
This will hold your bags of milk!
I got sick of Canadian supply management so I'm sticking it to the dairy producers in the only way I know…buying in bulk! Also, a couple of other posted models were a little too small for me.
This milk bag holder/jug will hold a 1.3333333 litre bag of milk (in Ontario, Canada, we get 4L of milk with 3 x 1.333 litre bags). The bags fit in the model nicely and only the very top is left exposed so you can nip the tip. I find the bags arrive from the store wet but they still slip in without issue.
I designed it so the arch of the handle could print without supports and I think it turned out well (close-up of this area is in the photos). Your finger takes most of the weight in this spot, so maybe a bit of sandpaper would help if it turns out too rough for you. Otherwise, I printed it stock settings for Creality K1 on Orca with generic PLA at 0.2mm layer height.
It would honour me if this model had a special place in your fridge. Cheers to #20 Ca!
Latest Edit
2024/07/16: The Mk II has arrived!
- The spout just kept getting into the way of the milk stream; I removed it.
- The holes in the bottom did not really make cleaning/drying easier; removed those.
- I added a small chamfer to the bottom.
- The walls at 2mm and floor at 4mm seem good and hearty, so that's the new standard.
- Original STLs have been moved into a folder.
------------
Previous Edits
2024/05/27: Upon request, I added another STL without holes in the bottom AND the walls/floor are twice as thick (2mm and 4mm, respectively). Note, I have not printed this version, but I included a section analysis screenshot of the model to verify that nothing terrible happened to the model when I made the changes.
2024/05/17: Upon request, I added an STL without holes in the bottom. This seemed like the way it should have been all along…