1 / 3
Haldis 3D Red Lizard Q1 V6 Ender 3/CR-10/ Shroud and fan Duct for Orbiter 2.0
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This might sound dumb but i just marked the orbiter 2.0 with a pencil on the PETG after i assembled it. then i drilled…
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 10
- Wydruki
- 0
- Wyświetlenia
- 235
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution
This might sound dumb but i just marked the orbiter 2.0 with a pencil on the PETG after i assembled it. then i drilled a few small holes and screwed in my m3 screws.
follow all print settings for petsfang
Category: 3D Printer Parts